FLIR CM83 Power Clamp Meter
FLIR CM83 Power Clamp Meter Features
Accurately analyze non-sinusoidal waveforms and noisy signals in VFD-controlled equipment.
Locate noise from different electrical draws to realign harmonics and reduce electro-mechanical equipment stress.
Analyze three-phase systems to measure power draw and verify if power is evenly balanced.
Measure hard and soft start-up inrush current spikes while equipment is ramping up.
Embed electrical measurements into thermal images captured by METERLiNK-enabled FLIR IR cameras for easier documentation.
Power Factor and Active Power
Monitor power quality improvements, such as start-up realignments on three-phase equipment.
Connect to Android devices for remote diagnostics in hard-to-reach or hazardous areas. Also, upload data without the need for special cords.
Bright Dual-LED Worklights
Make your work safer/easier in poorly lit locations especially useful when the lights are out or obstacles block your inspection targets.
Rugged & Shock-Resistant
Double-molded case design and extra thick rubber on the corners absorbs shock to enhance job-site reliability and long-haul durability.
CM83 Power Clamp Specifications
|AC/DC Current Range||599.9 A Max||+/- 2%|
|AC/DC Voltage||999.9 V Max||+/- 1% / 0.7%|
|Harmonics||1st-25th Order||+/- 5%|
|Total Harmonic Distortion||0.0 to 99.9%||+/- 3%|
|Inrush Current||599.9 ACA Max (Integration Time 100 ms)||+/- 3%|
|Active Power||9.999 kW to 599.9 kW, (10 V, 5 A min)||+/- 3%|
|Diode Test||0.4 to 0.8 V||+/- 0.1V|
|Capacitance||3.999 mF Max||+/- 1.9%|
|Resistance||99.99 kÎ© Max||+/- 1%|
|Continuity Threshold||30 Î©||+/- 1%|
|Frequency||20.00 Hz to 9.999 kHz||+/- 0.5%|
|Jaw Opening||37 mm (1.45, 1500MCM)|
|Category Rating||CAT IV-600V, CAT III-1000V|
|Bluetooth Range Max||32 ft (10 m)|
|Certifications||CE, UL, FCC|